Instructions for pasting wig stickers paste hairsystem into the scalp

This post is also available in: Tiếng Việt

When bald, using a scalp-like wig is the best solution for bald, hairsystem wig, there are many ways to attach a wig to the scalp. Hair dressing depends on the type of hair using the base filmtóc thật màng Poly siêu mỏng, hay tóc giả màng lưới ren. This article shows you how to paste the ultra-thin Poly-film wig into your scalp quickly and for the longest time.

The hair type with base membrane is Poly Ultra Thin

  1. If you use real hair with Poly Super Thin film without lace mesh, use a scalp Protector Scalp Protector Apply on your scalp, where you will apply hairsystem Water-based glue or Tape Hair Put on the scalp to stick the wig up. Sản phẩm dưỡng da đầu Scalp Protector will create a protective film between your scalp and the hair, sweat and head secreted by the skin that will break the bonding and product Scalp Protector This will prevent sweat or oil from breaking this bond, so it will take longer to stick and use hair on the scalp longer.
    Scalp Protector
    h1. Scalp Protector
  2. Apply tape on the perimeter of the system, as shown.
    h2. dán băng dính bao quanh viền
    h2. Tape the tape around the border
  3. Use positioning spray Just-rite Positioning on the areas where the tape will make contact with your scalp. Positioning spray will cause your adhesive to take a little longer to set, giving you extra time to perfectly position your hair system. The more you apply, the longer the time to set.
    Use positioning to easily align the hair before the glue adheres to the scalp
    use Just rite Positioning to easily align the hair before the glue adheres to the scalp
  4. Remove the back layer of the tape on the front hair area of the wig you use. Put the Hairsystem wig on your scalp and align the front hairline to the proper position.
    Align the front hairline to the correct position
    Align the front hairline to the correct position
  5. Remove the back of the tape on the rest of the back of your hair, to paste the rear part.
    Back cover correction on the head
    Back cover correction on the head
  6. Press the wig tightly on your head and swipe it back down to let the Positioning run out so that the tape can stick to your scalp.
    Press tightly and smooth down the hair.
    Press tightly and smooth down the hair.
  7. After locating the hair on the head, if the adhesive tape has not been adhered to due to the Positioning, wait until the adhesive tape is firmly applied to the scalp, then use a light brush and position the hair according to your will.
    Use a light brush to style
    Use a light brush to style

Leave a Reply